I was going to use this in a project but plans changed. It was in a friends Camaro that was doing an LS swap and i heard it run before it was pulled.I freshened a few things up with new gaskets and parts to make sure everything was good. It has 60lbs of oil pressure by running the oil pump with a drill. I removed the pan and intake to check everything and replace some gaskets but its very clean inside, cross hatching on the cylinders is visible and the rods have no play. I has been rebuilt but it can't have that many miles on it with how clean it is. NO TRADES, pick up only, sold as is, no warranty, serious buyers only, i have a hoist and can load it for you. Thanks for looking.
-350 chevy 4 bolt main block
-1965 327 closed chamber (double hump) heads, rocker studs have been pinned for a high lift cam, aftermarket springs, hardened push rods
- Cam specs unknown (has a choppy idle)
-double roller timing set
Melling HV oil pump with hardened shaft
-10:1 pistons
-rotating assembly was balanced
-new HEI distributor and wires
-AC delco plugs and oil filter
-new dual plane aluminum intake
- new water pump and some other parts to go with it.